Sản phẩm > Máy và thiết bị sau in > Máy bế & cấn nếp tự động BRAUSSE



Automatic Flatbed Diecutting & Creasing Machine with Stripping Station


Patent turbo spiral air blower pressing foot at feeder head
Four pick up and four forward suck heads with angle adjustment
Preloading device with rail cart and scaled gate
Non – stop feeder with automatic pile lift
Left and right side turbo air blower
Motorized side adjustment of pallet table
Electrical double sheet control
Fine air blast at lead edge for smooth thin paper transport
Sheet slow down device of feeder belts to assure accurate position of the sheet to the front lays with selective on/off switch
Synchronizing device to adjust the sheet positioning to the front lay by hand during production
Bullet catcher on the feeder entrance
Side lays on both sides push and pull convertible
Electronic side lay control to check the sheet position
Four individually adjustable front lays with dial read out at the operation side of the machine
Two electronic front lay controls by means of Omron Glasfiber optik to control the sheet arrival
Photo sensor safety barrier at pallet table floor level touching point

Die cutting Section

Precision worm gear crank toggle driving system to ensure smooth and dynamic lower platen movement
Precision stationery upper platen
Sandwich hardened cutting plate
Pneumatic push button diechase locking mechanism to ensure safe and operator friendly changing of the die
Pneumatic clutch/brake for main drive system
Servo motor drive impression on/off by button
Digital diecutting pressure tonnage display with maximum pressure limit protection
Seven high precision alloy gripper bar
High quality pre – stretched gripper bar driving chain
State – of – art 3 cam index gripper bar driving system to ensure smooth and precise gripper bar intermittent movement
Torque limit safety clutch to protect the index driving system in case of gripper bar crash
Double cam driven gripper opener and front lay swing frame without position restore spring for smooth and accurate sheet register and take off
Air blasting nozzle bar for stretching the thin paper before die cutting

Stripping Section

Triple action movement of the upper and lower stripping frames with lower spring loaded stripping pins
Motorized upper frame suspending hoister
Upper and lower stripping tool mounting frame can be pulled out for job set up and make ready
Remote control operation panel for jogging the upper frame up and down, easy and safe stripping tool set up and alignment
Quick stripping tool exchange device (optional)
Mechanical disconnecting of lower stripping frame when it is not in use

Delivery Section

Automatic delivery with non – stop curtain. This curtain moves into the delivery to catch the arriving sheets during the pile exchange
Five section brush brake each section angle adjustable individually
Air blower to press down the sheets
Rare and side joggers with easy position adjustment
Gripper edge stripping and removing system with conveyor belt to remove the gripper edge waste sideways to the drive side
Tape inserter with counter
Safety device to prevent the steel pile plate from clamping on the foot when it reaches at ground level


Maximum die cutting size: 1040 x 720 mm
(Maximum cutting size can be reached at 1040 x 730 mm when the quick locking system is dismantled from the die chase)
Inner size of chase: 1145 x 755 mm
Dimensions diecutting plate: 1080 x 736 mm
Maximum diecutting pressure: 300 T
Maximum mechanical speed: 7500 cycles/hour
Minimum gripper edge: 9.5 mm
General specifications:
Power supply for main motor: 11 KW.
Power supply for other motors: 9 KW.
Power voltage: 380V/50Hz

Specification of paper stock range:

Maximum sheet size: 1050 x 750 mm
Minimum sheet size: 400 x 370 mm
Stock range: a. Paper/cardboard 90g/m2 – 600g/m2
(subject to quality of the paper)
  b. Corrugated board Up to B flute or 4mm thickness (subject to quality of the corrugated    board)


Sản phẩm liên quan